Fab Supply Inc.
1775A Cortland Court, Addison, IL, 60101
Phone: 630.691.8665 • Fax: 630.691.8667
Email: info@fabsupplyinc.com • Website: www.fabsupplyinc.com
All Categories > Conventional & Precision Planed Press Brake Tooling > 3 & 4-Way Dies > Item # 3V67  


Item # 3V67, 3 & 4-Way Dies

Multiple openings can be machined into a single steel bar. These dies are typically used to replace single-vee dies and can significantly reduce die-change time.

NOTE: Unless specified, all three-way dies are furnished with the smallest vee opening at 60 degrees.






Specifications

Block Size
6.75 in

Number of Vees
3

Vee Openings
1.500 in
3.000 in
5.000 in

Illustration C

Illustration D

Illustration E

 View
A four-way die held by a combination die holder is shown in the illustration. General-purpose dies can be substituted for the four-way when it is removed.

Illustration F

 View
A general-purpose die can be used directly over a combination die holder provided the press has sufficient stroke (or ram adjustment).

Illustration G

 View
A filler block may be required when the combination holder is low and the press does not have sufficient stroke (or ram adjustment) to close the tool set.

Illustration H

 View
The four-way die can be set directly on the bed of the press if it does not have sufficient open height. This practice is not recommended, due to the potential for damage or wear of the bed surface.

Option
Flame Hardening



Print Back